Compool Cp3800 User's Guide download pdf (Page 69)

Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide

First Time System Start-Up

The following information describes a basic system start-up procedure. Before you power up the EasyTouch

system at the Load Center first check the following:

Check Electronics

Check that the following plugs are seated correctly on the EasyTouch Load Center motherboard. For

connector locations, refer to the EasyTouch System Wiring Diagram on page 60.

• Relay connectors - FLTR PUMP - AUX 1 - 7

• Temperature sensors connectors - WATER, SOLAR, AIR

• Transformer wire harness - J1

• Heater control connector - ELEC HTR and GAS HEATER (J19)

System Test

Follow the steps below to test the EasyTouch control panel to activate the heater, valves and pumps. This test

assumes that all system equipment has been properly installed and connected to the EasyTouch Load center.

Testing Valve Actuators and Pumps:

Use the following steps to test the valve actuators (CVA24T) for proper rotation.

To test the valve actuators and pump:

1. Switch on the electrical power at the house breaker.

2. Switch on the EasyTouch Load Center. You may need to switch on the breakers on the Load Center.

3. Press the Mode button to enable “Service” mode.

4. Press the Valve (V) button to select “Pool” mode.

5. Press the Filter Pump (F) button to activate the filter pump. Water will be removed from the pool

and returned to the pool. A spa bypass line divert a small amount of water to the spa. Make sure the

filter pump turns on correctly. If the pump has two speeds: Press the button one time to run the pump

in low speed. Press the button again to run the pump in high speed. Press the button again to switch

the pump off. A Two-Speed pump has to be configured in the 2-Speed menu (see page 42).

6. Set both valve actuators (CVA-24T) for suction and return. Use the toggle switch on the rear of the

CVA-24T to withdraw and return water from the pool.

7. Press the Valves (V) button. Step through all four valve positions: Pool, Spa, Fill, Drain. Make sure

the valves turn on correctly and the water is moving in the correct direction for each position. If

necessary, flip the actuator toggle switch to change the direction of the water.

Note: With the filter pump operating, if water is not being removed and returned to the pool,

it may be necessary to reverse the RETURN with VLV A (or VLV B) plugs on the EasyTouch

motherboard.

Testing the Auxiliary Relays

Affix the auxiliary relay labels to the appropriate buttons on the EasyTouch control panel and/or the

EasyTouch Indoor Control Panel. If necessary, write the function on the control panel.

1. Step through the rest of the auxiliary buttons. Notice which button turns on which equipment. You

may need to walk the property to find what each button turns on.

2. Write down what each button switches on, including the number of the circuit. You need this

information when you set up the Indoor Control Panel.

3. Label the circuit buttons on the outdoor control panel and the EasyTouch Indoor Control Panel.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 87 88

No comments

Compool Cp3800 User's Guide Page 69