Compool Cp3800 User's Guide download pdf (Page 56)

Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide

Settings Menu: Man Heat (Off/On)

By default manual heat (Man Heat) is set to “On,” which allows your spa to begin to heat whenever it is

manually switched on, (by pressing the Valves (V) button and Filter Pump (F) button on the outdoor control

panel or the Spa button on the Indoor Control Panel), even if the Heat menu setting is set to “OFF” (see page

25). Your spa will also begin to heat when switched on by the iS4 Spa-Side remote. This feature allows you to

program your spa to filter daily with the heater set to off, and then be ready to heat whenever the Spa button is

pressed manually.

Man Heat

To enable or disable spa manual heat when switched on manually:

Right button:: Select Off to disable or On to automatically begin spa heating

whenever the spa is switched on manually.

Press the Menu button to save the settings and to return to the main screen.

Settings Menu: Calibration

The EasyTouch system includes two temperature sensors (10 kΩ) for water and ambient air temperature. You

can also add an additional sensor for controlling solar heating systems. Generally, these sensors are accurate

and you do not have to calibrate them. However, long plumbing runs and water features can cause

temperatures at a body of water to be different from the temperature sensor reading. You can manually

recalibrate the sensors to adjust for this. You only need to calibrate one body of water, since the temperature

sensor is common to both the pool and spa. The system must be in “Service” mode to calibrate sensors.

Calibration

Before you start, you need an accurate all weather thermometer. If you are calibrating the air sensor, wait until

the sensor is not in direct sunlight. For the air temperature sensor, make sure that the sensor is located in the

shade for accurate readings.

To calibrate the water, air and solar temperature sensors:

1. Press the Mode button on the control panel to place the system in “Service” manual mode.

2. Press the Filter Pump (F) button to switch on the pool/spa filter pump.

3. Place the thermometer in the spa or pool water. Take an accurate temperature reading. When

calibrating the air sensor, place the thermometer next to the air sensor. The air sensor is normally

located near or under the EasyTouch load center enclosure, not inside the enclosure. Take an

accurate temperature reading in the shade.

4. Use the Up or Down buttons to raise or lower the water temperature to match the corresponding

thermometer temperature reading.

5. After calibrating the water sensor, use the Right button to select the “AIR”

setting and repeat step 4 and repeat the procedure for the solar sensor.

Ensure that the solar sensor is in the sun for accurate readings.

6. After calibrating all the sensors, press the Menu button to save the settings

and to return to the Settings menu options. Press the button again to return

to the main menu options or press again to return to the main screen.

MENU ▼ SETTINGS ▼ CALIBRATION CALIBRATION

Getting There

▲



Calibration

Water: 70°F

Air: 80°F

Solar: 90°F





iSx Pump Cntrl

QuickTouch

Man Heat [On]

Calibration



MENU ▼ SETTINGS ▼ MAN HEAT [On/Off]

Getting There

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 87 88

Comments to this Manuals

No comments

Compool Cp3800 User's Guide Page 56

Comments to this Manuals

Related products and manuals for Above ground pool accessories Compool Cp3800