Compool Cp3800 User's Guide download pdf (Page 55)

Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide

Settings Menu: QuickTouch (QT4) Wireless Remote

The QuickTouch QT4 wireless remote controller provides switching of up to four circuits. For example, you

can use the QT4 wireless remote to activate the spa circulation, and for operating three auxiliary pieces of

equipment (such as heat enabled, lights, jet pump, heat boost, air blower, waterfall, etc.).

Each of the four functions on the QT4 wireless controller has an on and an off button. To switch a circuit on

or off, press and hold the appropriate button for at least a full second.

The QT4 buttons can be assigned to any available circuit. However, the QT4 has the following preset circuits

assigned to the four buttons:

• Spa button activates the spa circuit.

• A button activates Auxiliary 1 circuit.

• B button activates Auxiliary 2 circuit.

• C button activates Auxiliary 3 circuit.

Assign QT4

To assign circuits to the QuickTouch wireless controller buttons:

Up/Down buttons: Select a circuit to assign to one of the QuickTouch wireless

remote buttons. You can set up to four circuits (1/4, 2/4, 3/4, 4/4).

Right button: Select the circuit setting.

Up/Down buttons: To configure the first button (1/4) on the QuickTouch wireless

remote. Use these buttons to scroll through the circuit names and find the circuit that

you would like to assign to the first button. The generic circuits selections are: None,

Spa, Pool, Aux 1-7, Feature 1-8, Aux Extra, Heat Boost and Heat Enable. Selecting

“None” does not assign a circuit. “Aux Extra” is only available if the Solar output

(J17) plug on the EasyTouch motherboard is not being used for solar equipment. Use

the Solar button to switch the “extra” auxiliary circuit on and off (see page 5).

Note: The “Heat Boost” feature will switch on the heater for seven minutes to

increase the spa water temperature. Each time the spa Heat Boost button is

pressed, the temperature will increase about 1° F. The temperature will not go

beyond the 104° F limit.

Right button: Assign the next circuit (2/4).

Up/Down buttons: Select the first digit for the circuit number (1/4, 2/4, 3/4, 4/4),

then repeat the procedure for the other three buttons.

Press the Menu button to save the settings and to return to the Settings menu

options. Press the button again to return to the main menu options or press again to

return to the main screen.

MENU ▼ SETTINGS ▼ QUICKTOUCH ASSIGN QT4

Getting There

▲



Assign QT4

Circuit: 1/4

[SPA ]



1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 87 88

Comments to this Manuals

No comments

Compool Cp3800 User's Guide Page 55

Comments to this Manuals

Related products and manuals for Above ground pool accessories Compool Cp3800