Compool Cp3800 User's Guide download pdf (Page 24)

Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide

EasyTouch Menus

From the EasyTouch control panel menus you can schedule everyday pool/spa, heating, filtration and cleaning.

Lights and laminars can also be scheduled to switch on and off at specific times. The “Settings” and

“Schedule” menus are typically used most often for daily spa and pool operations. The “Settings” menu is used

by the pool installer to setup installed equipment which is connected to each output relay (filter pump, auxiliary

relays, heater, valves, lights, etc.). For EasyTouch equipment installation instructions, see the EasyTouch

Installation Guide (P/N 520584).

Main Screen

The EasyTouch main screen displays the current mode of operation

(AUTO/SERVICE/TIMEOUT), heat source being used, spa (or pool) actual water

temperature (95° F), current heater set point temperature (100° F) and the current

ambient air temperature (air sensor). Degree units can be displayed in either

Fahrenheit (default) or Celsius (see page 44). If the second display line is blank and

the heat source is not displayed, there is no spa or pool function currently active. The

main screen is automatically displayed if there is no control panel menu activity for

five minutes. If there is an IntelliChlor salt chlorinator generator being used, pool and

spa sanitizer settings, and salt levels can be viewed in the Diagnostics, “Chlorinator,”

settings (see page 53).

Main Screen Description

AUTO: EasyTouch is in normal (automatic) operating mode. For information about “Service” and “Timeout”

operating modes, see page 4.

HEATER: The selected heat source as selected in the “Heat” menu (see page 25). The heat options are:

•

OFF - No heating even though pump and other circuits may be operating.

• HEATER - Gas heater only.

• SOLAR ONLY - Solar heating system to be the only heat source. In order to display “Solar Pref.” on

the main screen, you must first enable solar in the “Solar” menu (see page 42).

• SOLAR PREF. - (Solar Preferred) - For when solar and gas heating are combined, and you want to

use solar heating only when it is most effective. In order to display “Solar Pref.” on the main screen,

you must first enable solar in the “Solar” menu.

SPA: “SPA” is displayed after the Valves (V) button is pressed to set in “spa” mode then the Filter (F)

button is pressed to switch the filter pump on, rotate the valve actuator (to isolate spa water from pool water),

and switch the heater on (if enabled in the “Heat” menu). Pressing the Valves (V) button alternates between

“Pool” and “Spa” mode. The temperature unit displayed on the left side is the actual water temperature (95°

F) and the set point temperature (100° F) as set in the “Heat” menu is displayed on the right side. If this

display line is blank, it indicates no spa or pool function is currently active. For Hi-Temp controls (EasyTouch

single body system), see page 37.

POOL: “POOL” is displayed after the Filter (F) button is pressed to switch the filter pump on, rotate the

valve actuator to isolate the pool water from the spa water, and switch the heater on (if enabled in the “Heat”

menu). Pressing the Valves (V) button alternates between “Pool” and “Spa” mode. The temperature unit

displayed on the left side is the actual water temperature (95° F) and the set point temperature (100° F) as set

in the “Heat” menu is displayed on the right side. If this display line is blank, it indicates no spa or pool function

is currently active. For Lo-Temp controls (EasyTouch single body system), see page 37.

AIR: Displays the actual outside ambient air temperature (70° F) as recorded by the air sensor located near

the EasyTouch load center.

DAY and TIME: The current system day and time (AM/PM). See the “Clock” menu to set the system day and

time (page 31).

AUTO HEATER

SPA 95°F / 100°F

AIR 70°F

MON 09:30 AM

AUTO

AIR 70°F

MON 11:30 AM

AUTO HEATER

POOL 85°F / 95°F

AIR 70°F

MON 10:30 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 87 88

Comments to this Manuals

No comments

Compool Cp3800 User's Guide Page 24

Comments to this Manuals

Related products and manuals for Above ground pool accessories Compool Cp3800